Halcyon arrived with his car, here is a before picture.

Halcyon had a few dings as well which had been touched up. He was also keeping his Toyota logo, so his pattern was pre-cut to fit the emblem.

Alan installs the top hood piece!

Jeff watches as Alan installs

Piece #1 is done. You can see the edge particularly in this piece because of the low angle lighting, later in the sun it is barely visible.

Starting piece number 2 on the car.

Alan stretches piece #2 a little for the best fit.

The new pattern piece #3 that does not go all the way to the bottom which makes the install MUCH easier! (the lower pieces fill this area in)

Smoothing down piece #3

The finishing touches with felt pad and hairdryer.

The middle spoiler lip, this is called piece #5 in the new pattern.

The spoiler is done. It was starting to get a little bit darker so the garage lights came on.

Alan gives the car a last minute check in the sun to make sure everything is attached as it should be.

Jeff and Alan, another Thumbs Up!

I wanted to take a picture from another angle to show that the edge line disappears depending on the angle and the lighting.